Then you know what you need, and you should not have to read a website to get it. Parts, belts, the same machine four inches wider, or a drawing for the frame you are building it into — this page is the short way to all of it.
Nine calls in ten are one of these. Say which one and the answer takes a minute.
You have one running and you want another exactly like it. Give us the serial number off the plate and we will build the same machine with the same options.
Reorder a machineThe job grew and the piece no longer fits. Tell us what you run now and how much wider it needs to be, and we will tell you which machine that lands on — often the next size up, sometimes the same one with a different setup.
Check the widthBelts are the only thing that genuinely wears. Separators, sensors, rollers and shafts are on the shelf, including for machines older than most of the people running them.
Order partsYears of naming have left a lot of plates in the field that do not match anything on this site. It does not matter much — the machines are still built the same way, and the parts still fit. Read the plate to us and we will tell you what you have.
The C line (C12, C12E, C14, C20) is discontinued
Most of the feeders we make never carry our name on the floor — they go inside somebody else's machine. If that is you, this is what usually matters.
Feed on a signal from your controller, hand back a count, and stop when you tell it to. On demand, batch, or continuous, whichever your cycle needs.
Stands and conveyors are height-matched to what the feeder serves. Tell us the deck height you are feeding into and it arrives set for it.
Footprints, mounting points and clearances for the frame you are designing around it. Ask and we will email them.
If you are putting the same feeder into every unit you ship, we will hold the configuration and the price so nobody has to re-specify it each time.
Dealers and resellers: same phone number, same people. Terms and volume pricing are a conversation, not a form.
Serial number, model, or a photograph of the machine if the plate has given up. We will work out what you have and what you need.
